Set of joycons on the table today. Customer wanted them to lock properly to the console.
First off. This is why they'll stop locking. The plastic lock Nintendo uses gets worn away over time.
I replaced this with metal locks.
Went to correct his analog while I was in. Did so. Found out his L button had come completely away.
This is an easy fix. What's not easy is it the R button on the right Joycon has come away... Because it's not just a simple daughter board like the left joycon has.
Opened the right one again. Saw the switch had crumbled off for the R button. Saw some hope. Each pad still had some silver attached. Soldered a new one on. Did it work? Nope. But everything else looked good.
Didn't charge the customer for anything other than what they had originally been quoted, but definitely wanted to go that extra mile.
0 comments:
Post a Comment